How To Install Bali Cellular Blinds Inside Mount

Within Mount

1) Measure the width inside the window opening at the top, and round down to the nearest 1/viii" measurement.

ii) Measure the height inside the window opening from the top of the window opening to the window sill. If your window does not have a sill, measure to the point yous would similar the blind to attain.

3) Do not take whatsoever allowances on the height or width. The factory will take all required allowances on an inside mount.

iv) Because the manufactory takes deductions on the textile width some windows may have visible light gaps visible on the left and right border. To eliminate lite gaps and for increased privacy it may be necessary to society an outside mount. See measuring instructions below.

Exterior Mount

1) Tip-to-tip: Measure out the distance from the outer near points yous would like the headrail to extend. Depending on the product, the cloth width volition be up to 1-3/8" narrower then the tip-to-tip measurement provided. The exact amount of material deduction can be obtained by contacting customer service. To minimize light leakage the blind should overlap the window opening past at to the lowest degree ii" on each side for a total of 4" on entire width.

2) Fabric width: Measure the distance from the outer almost point y'all would similar to textile to extend. Add together the outside mount textile deduction to this measurement (typically 1-1/8" to ane-3/eight"). The exact corporeality can be obtained by contacting customer service to determine cloth deductions on outside mountain applications.

3) Measure distance from where the top of the blind will be located to the window sill. The bullheaded should overlap the window opening on the top by at to the lowest degree 1-1/2". Some products peradventure require more and so 1-1/two" above the window for mounting hardware. Please review product specifications on desired product for verbal apartment vertical surface area requirements. If flat vertical surface expanse exceeds 1-1/2" utilise specified amount to determine overlap above the window opening. If there is no window sill, measure to the point you would similar the blind to reach.